EasyManua.ls Logo

Motorola ST7500 - 2.2.5 MicroSD Micro CRYPTR Card; 2.2.5.1 Installing the MicroSD Micro CRYPTR Card

Motorola ST7500
138 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Figure 10: Closing the SIM/microSD Door
IMPORTANT: Ensure that the latch on the SIM/microSD door is locked in place before
placing the battery into the radio.
8 Install the battery and attach the battery cover.
2.2.5
MicroSD Micro CRYPTR Card
The microSD card is supported only by radios equipped with a SIM/microSD card slot. The slot is
located under the battery at the back of the radio. If the SIM/microSD card slot is not available, the
radio uses its internal flash memory to store data.
The Micro CRYPTR card is supported only by radios equipped with a microSD card slot. The slot is
located under the battery at the back of the radio.
The radio supports two types of the microSD cards:
Micro Secure Digital Card (microSD card) with a capacity of 2 GB.
Micro Secure Digital High Capacity Card (microSDHC card) with a capacity from 4 GB to 32 GB.
NOTICE:
The radio only supports the following characters to compose file names:
1 Numeric digits.
2 English alphabetic characters.
3 Space.
4 Non-alphabetic characters: ! # $ % & ' ( ) - @ ^ _ ` { } ~.
Before using non-alphabetic characters, make sure your computer system supports them.
To achieve the best radio performance, use microSD cards with the minimum write speed of at
least 6 MB/s (Class 6 or higher). Cards with the write speed lower than 6 MB/s slow down the
performance of the radio.
2.2.5.1
Installing the MicroSD Micro CRYPTR Card
Prerequisites:
Your radio is equipped with a microSD card slot.
Procedure:
1 Remove the battery.
MN004519A01-AK
Chapter 2: Getting Started
25

Table of Contents

Related product manuals