3.3.4.1
Preempting Group Calls
NOTICE: Your radio can only support either the D-PTT Tone feature or D-PTT Preempt Group
Call feature at a time.
Procedure:
1 Your radio receives a Group Call.
2 Press the PTT button twice on the radio or the Remote Control Unit (RCU).
Call preempt is triggered.
3.3.5
Selecting DMO Communications Options
When and where to use:Helps to communicate with other radio users on the same talkgroup through
the Gateway or Repeater.
Procedure:
1 From the home screen, press Options.
2 From the home screen, press the Menu/OK key.
3 Press Config.
4 Select Networks→DMO Config.
5 Select one of the following options:
• MS - MS – Your radio can communicate only with other radios within its range.
• Gateway – Your radio uses a gateway to communicate with the infrastructure.
• Automatic – Your radio uses the first available gateway for that talkgroup.
• Specific – Your radio uses only the Gateway with the specified Gateway address for that
talkgroup. If your radio displays Selected Gateway: None, press Edit to enter the
current gateway address.
• Repeater – Uses the first available repeater for that talkgroup.
• GW + Rep – Uses the first available gateway or repeater for that talkgroup.
• Automatic – Uses the first available gateway for that talkgroup.
• Specific – Uses only the Gateway with the specified Gateway address for that talkgroup.
If your radio displays Selected Gateway: None, press Edit to enter the current
Gateway address.
NOTICE: When the Gateway and the Repeater cannot be communicated even
though a talkgroup to use them is configured, the radio attempts the direct MS-MS
communication.
Your service provider can disable any or all of these options.
When your radio detects the appropriate Gateway and/or the Repeater, the Gateway and/or Repeater
icons turns solid, respectively.
MN004519A01-AK
Chapter 3: Modes
60
To Next Page
Loading...
