5 Highlight the required device and select Connect.
NOTICE: Press accessory PTT button to improve the connection between the accessory
and radio.
6 Highlight the required device and press Menu/OK.
NOTICE: Press accessory PTT button to improve the connection between the accessory
and radio.
7 If needed, enter a PIN code or a passkey.
NOTICE: If you enter an incorrect PIN code and the subsequent paring attempts take too
long or result in an error message, power the Bluetooth device off and on. The radio
accepts 3 logging attempts.
4.8.4
Devices
This menu item lists all devices paired with your radio and allows you to perform the following
operations:
• Connect a device.
• View and change device details.
• Disconnect a device.
• Delete a device.
4.8.4.1
Connecting or Disconnecting Devices
Prerequisites:Only pre-approved sensor devices can be used. The service provider is responsible for
configuring the radio to work with specific devices. See Add Bluetooth Devices on page 117.
Procedure:
1 From the home screen, press the Menu key.
2 From the home screen, press the Menu/OK key.
3 Select Bluetooth→Devices.
4 Select BT Devices
5 Highlight the required device and press Menu/OK. Select Connect/Disconnect.
NOTICE:
Depending on languages installed on the radio, some characters in names of devices
might not be displayed properly.
Radio-initiated automatic reconnection with several remote Bluetooth devices at the
same time cannot be guaranteed to be successful in 100%, due to the fundamental
nature of Bluetooth. In case the reconnection fails after a power cycle (power off and
power on of the radio), reconnect the device manually.
4.8.4.2
Managing Devices
Procedure:
1 From the home screen, press the Menu key.
2 From the home screen, press the Menu/OK key.
MN004519A01-AK
Chapter 4: Main Menu
94
To Next Page
Loading...
