2.12
Selecting Talkgroups
Follow these procedures to select talkgroup manually. If the selected talkgroups is an InterSystem
Interface (ISI) talkgroup, your radio can migrate to another talkgroup linked network, changing the
talkgroup automatically.
Prerequisites:Talkgroups are pre-set by your service provider.
Procedure:
From the home screen, use one of the following methods:
• Toggle the Talkgroup Selector button until the required talkgroup name is displayed.
NOTICE: The Talkgroup Selector only list out the talkgroups of the current folder. To
view talkgroups from other folders, see Setting Talkgroup Folders on page 91 to change
folders.
• Press Left or Right Navigation key. Press Select to confirm.
• Select Options→TG by abc. Enter a talkgroup name and select the talkgroup name from the
list.
• Select Options→TG by Folder. Select a folder (for example, Favorite) and then a talkgroup
name.
NOTICE: Your radio can access up to three levels of the folder structure.
• Select Menu/OK→Favorite TGs. Select the required talkgroup and press Menu/OK to confirm.
• Select Menu/OK→TG Folders. Select the required talkgroup folder and press Menu/OK to
confirm.
NOTICE: Your radio can access up to three levels of the folder structure.
2.13
Entering TMO or DMO Mode
Prerequisites:Your service provider can enable this mode.
Procedure:
1 From the home screen, press Options.
2 From the home screen, press the Menu/OK key.
3 Select Networks.
4 Select Trunked Mode/Direct Mode.
NOTICE: Changing talkgroups using the Talkgroup Selector button also changes the
network mode accordingly for the selected talkgroup when in favorite folders.
2.14
Covert Solution
NOTICE: This is a Software Selling Feature.
MN004519A01-AK
Chapter 2: Getting Started
47
To Next Page
Loading...
