2.10.1
Using High Audio
When and where to use:Placing or receiving a Phone, PABX, or Duplex Private call.
Procedure:
1 Hold your radio in a vertical position with its top microphone 5 cm to 10 cm away from your
mouth.
2 Speak into the top microphone and listen through the internal speaker.
Keep the antenna at least 2.5 cm from your head and body.
2.10.2
Using Low Audio
When and where to use:Placing or receiving a Phone, PABX, or Duplex Private call.
NOTICE: It can also be used in group mode when discrete listening is required.
Procedure:
1 Hold your radio as you would a telephone.
2 Speak into the bottom microphone and listen through the earpiece.
Keep the antenna at least 2.5 cm from your head and body.
2.11
During a Call
During the call, label of the right Soft key indicates the next possible change. Accessory default setup
is:
Table 17: During the Call
Soft Key Label Audio Setting
Spkr Audio goes to the main speaker (Speaker HIGH is displayed)
Erpce Audio goes to the earpiece (Speaker LOW is displayed)
PHF Audio goes to the Personal Hands Free (Speaker LOW is displayed)
During the call, if the audio is routed to different setting, the following is displayed:
Table 18: During the Call
Audio Setting Displayed Notification
Audio goes to the main
speaker
Speaker HIGH
Audio goes to the earpiece
Speaker LOW
Audio goes to the Person-
al Hands Free
Speaker LOW
NOTICE: You can change the High or Low audio setting using the OTB. See One-Touch
Buttons on page 50.
MN004519A01-AK
Chapter 2: Getting Started
46
To Next Page
Loading...
