6809509A89-O March 01, 2007 29
Level 1 and 2 Service Manual Disassembly
12. Remove the CLI dispaly from the Flip pcb.
13. To replace the CLI display, insert the CLI flex into the ZIF connector & close the latch.
14. Properly align the CLI display onto the bracket & press down on the CLI flex to ensure
proper contact.
15. Paste a new kapton tape across the CLI flex & ZIF connector.
16. To replace the main display lens, properly align the display lens on the bracket.
17. Align the display flex to the flex connector & gently press it downwards for proper contact.
Figure 18. Removing the Display Module Lens
➧
A new adhesive strip might be required for proper securing of the CLI Flex in place on the
Flip pcb.
To Next Page
Loading...
Need help?
General
