ioLogik E2200 Series Using ioAdmin
Basic Functions: Add, Connect, and Disconnect
Add ioLogik ioLogik device: Select ioLogik tag and right click the tag. Select the “Add ioLogik device”
command to add an ioLogik device or Active OPC server manually.
Connect: Select the “Connect” command to try connecting over the network to the selected ioLogik.
Disconnect: Select the “Disconnect” command to drop the network connection with the selected ioLogik.
Advanced Functions: Delete, Restart, Reset, Import/Export Config File
You must be logged in as administrator to use these commands.
Delete ioLogik device: Select this command to remove the selected ioLogik.
Note: The target must be disconnected first to use this command.
Restart System: Select this command to restart the selected ioLogik.
Reset to Default: Select this command to reset all settings on the selected ioLogik, including console
password, to factory default values.
Export System Config: Select this command to export the selected ioLogik’s configuration to a text file. We
strongly recommend that you use this method to back up your configuration after you have finished configuring
the ioLogik for your application.
Import System Config: Select this command to load a configuration for the selected ioLogik from a
configuration text file. The new configuration will not take effect until the ioLogik has been restarted. This
command can be used to restore a configuration after loading the factory defaults, or to duplicate a
configuration to multiple ioLogik units.
To Next Page
Loading...
Need help?
General
