ioLogik E2200 Series Using ioAdmin
Using ioEventLog
Installing ioEventLog
ioEventLog is a Windows utility provided to monitor the ioLogik E2200 series and attached I/O devices. It can
be used from anywhere on the network.
ioEventLog can be downloaded from Moxa’s website.
1. Installing ioEventLog from website:
a. First click on the following link to access the website’s search utility:
http://www.moxa.com/support/search.aspx?type=soft
b. When the web page opens, enter the model name of your product in the search box.
c. Click the model name and navigate to the product page, and then click on ioEventLog, located in the box
titled Software.
d. Download and then unzip the file. Run SETUP.EXE from that location.
The installation program will guide you through the installation process and install the software.
2. Open ioEventLog: After installation has finished, run ioEventLog from Start Program Files MOXA
IO Server Utility ioEventLog.
Note: or you can download ioEventlog straight from the following website
(
http://www.moxa.com/support/download.aspx?type=support&id=1152
)
Basic Functions
ioEventLog is installed along with ioAdmin. It is designed to help you keep a record of ioLogik status events over
the network. The log is stored on the Windows PC. You will need to set up your ioLogik E2200 to send status
events to the PC’s IP address. The following events are monitored:
• cold start
• warm start
For each event, the following information is provided. The log can be sorted by any of these fields:
1. event type
2. event date and time
3. ioLogik server source name
4. source IP
5. destination IP
6. host date and time
7. Source model
To Next Page
Loading...
Need help?
General
