2-1
Chapter 2
Installation and Set-up
Receiving
Upon receipt of the unit, inspect the shipping carton for signs of visible
damage. Report any damage to the carrier and note it on the delivery
receipt. The unit must be stored in a dry, secure place prior to its
installation and use. Store unit in the original shipping carton.
Unpacking the System
To unpack the equipment:
1.
Carefully remove the Chillgard RT Monitor from its shipping
container(s) in order to prevent damage to sensitive electrical
components. If any damage is found, report it to the shipper
immediately.
WARNING
Do not install or operate a damaged unit. It may not function
properly and may not alert you to any gas conditions.
2.
Search through all packing material and containers to avoid
Inadvertently discarding usable or valuable parts. Report any
shortages immediately to MSA.
The contents of the shipping carton are:
• instrument
• manual
• end-of-line filters (may be purchased separately).
Retain the original packing form for re-use in the event the unit
must be returned for service.
3.
Using a screwdriver, loosen the two latches on the Chillgard RT
door (FIGURE 2-1) by turning 1/4 turn counterclockwise.
4.
Open the front door.
Initial Inspection
With the front door open, carefully inspect components and assemblies
inside the enclosure. If damage or shortage is evident, advise and
promptly file the proper claim with the carrier.
To Next Page
Loading...
