5-1
Chapter 5
Maintenance
General Maintenance
Under normal operation conditions the Chillgard RT Monitor requires
minimal maintenance. The end-of-sample-line filter(s) should be
examined regularly for dirt/dust build-up and replaced when necessary.
If the filter(s) become severely clogged with dust, the flow rate will
eventually fail and a flow alarm will occur. If the end-of-sample-line
filters are used and serviced correctly, the filters installed inside the
monitor should rarely require replacement; however, these internal
filters must be inspected periodically.
Obtaining Replacement Parts
To obtain replacement parts, address the order or inquiry to:
MSA Corporate Center
1000 Cranberry Woods Drive
Cranberry Township, PA 16066
or call, toll-free, 1-800-MSA-INST.
WARNING
Use only genuine MSA replacement parts when performing
any maintenance procedures. Failure to do so may seriously
impair unit performance. Repair or alteration of the Chillgard
RT Monitor, beyond the scope of these instructions or by
anyone other than authorized MSA service personnel, could
cause the product to fail to perform as designed and
persons who rely on this product for their safety could
sustain serious personal injury or death.
To Next Page
Loading...
