To Next Page

To Previous Page

2-30

MS-6728 ATX Mainboard

BATT

IrDA Infrared Module Header: JIR1

The connector allows you to connect to IrDA Infrared module. You

must configure the setting through the BIOS setup to use the IR function.

JIR1 is compliant with Intel

Front Panel I/O Connectivity Design Guide.

Chassis Intrusion Switch Connector: JCI1

This connector is connected to a 2-pin chassis switch. If the chassis is

opened, the switch will be short. The system will record this status and show

a warning message on the screen. To clear the warning, you must enter the

BIOS utility and clear the record.

JIR1

JCI1

GND

CINTRU

Pin Signal

1NC

2NC

3 VCC5

4 GND

5 IRTX

6 IRRX

JIR1 Pin Definition

Questions and Answers:

Need help?

Do you have a question about the MSI 865PE NEO2-LS - Motherboard - ATX and is the answer not in the manual?

MSI 865PE NEO2-LS - Motherboard - ATX Specifications

General