MSSC Smart-Jet Plus - Operation Controls; Print Start;Stop and Purge Functions

USER MANUAL V1.0 | Updated January 19, 2019 30
Press ESC to go back to the main screen. Confirm “Yes” and input name for message, after
complete press Enter.
Status machine
Display settings and status of the machine. From the main screen of machine, select Message
and use down arrow keys to go to Information and press Enter.
ITEMS
DETAIL
Ink level
Current ink in the cartridge (ml)
Speed
Current print speed (m/min or ft. /min)
Density
Current density
Resolution
Current resolution
Delay
Current delay time
Print mode
Current print mode
Repeat
Number of prints repeated on the same object
Delay
Distance between 2 prints
Maximum
Number of prints left based on the current ink level, density and resolution
Operation
Start
Change status of machine from stopped to start print.
Select Operation  Start to begin to print. Your message content along with other setting
parameters will be displayed while printing.
ITEMS
DETAIL
Prints
Number of prints have been printed
Ink levels
Current amount of ink in the cartridge (ml)
Speed
Current speed (m/min)
Resolution
current speed (m/min)
Stop
Change status of machine from start printing to stop.
To stop print, press ESC to go back to the main screen. Use  or  arrow keys to go to
Operation, select Stop to stop printing.
NOTES:
 Machine should be stopped before doing other settings.
 Shortcut key to Start / Stop: CTRL + SHIFT + ENTER.
Purge
Select Operation  Purge to jet the ink out from all of nozzle this will help clean the print head.
Connect / Disconnect PC
Select to connect or disconnect Machine with PC.