MSSC Smart-Jet Plus - System Settings; Speed and Resolution Configuration; Density Adjustment

USER MANUAL V1.0 | Updated January 19, 2019 31
Settings
From main menu select Settings to access settings menu.
From the Settings menu, use the arrow keys to move the cursor to your desired setting,
press Enter to select and begin editing.
NOTES:
Press Enter to save. Press ESC to go to main menu and apply new settings.
Speed
Set print speed with 2 print modes: None Enc. and Encoder
None Enc (No encoder)
Operating Machine without encoder. Under this mode, print speed must be set to synchronize
with conveyor speed to print good quality message (input value at Value).
Encoder
Encoder is recommended where speed of the conveyor is varied. Under this mode, print
speed of Machine will be synchronized with conveyor speed to ensure the best print quality.
Ensure you have an encoder installed with machine via the DB15 connector.
NOTES:
 Minimum speed: 1m/min
 Maximum speed: 228m/min
From the Settings menu, use  or  arrow keys to move the cursor to Speed, press Enter. Press
Enter again at Select to choose None Enc. or Encoder mode. Press Enter to apply settings.
Resolution
Set the amount of ink drops on an inch. From the Settings menu, use  or  arrow keys to go
to Resolution, press Enter. Select your desired resolution and press Enter.
Optional resolutions with standalone mode:
 300x300 dpi.
 300x150 dpi.
 300x100 dpi.
Optional resolutions with PC mode:
 600x600 dpi.
 600x300 dpi.
 600x150 dpi.
 600x100 dpi.
 300x300 dpi.
 300x150 dpi.
 300x100 dpi.
Density
Set the optical density of the print.
There are 5 levels of Density to apply.