BASIC TROUBLESHOOTING
16
Leak-down test
A leak-down test is the preferred method to test the
engine’s ability to compress the charge. It will also
show where pressure is leaking from.
To perform a leak-down test:
NOTE: A leak down test pressurizes the com-
bustion chamber with an external air source and
will allow the technician to listen for air “leaking “
at the valves, piston rings and the head gasket.
NOTE: These are general instructions. Read
and follow the instructions that came with the
tester before attempting to preform this test.
• If possible, run the engine for 3-5 minutes to
warm up the engine.
• Remove the spark plug and air filter.
• Find top dead center of the compression stroke.
CAUTION: If the engine is not centered at top
dead center, the engine will rotate when com
-
pressed air is introduce to the combustion cham-
ber.
1. Find top dead center by following the steps
described in the valve lash section of Chapter 1:
Introduction
2. Thread the leak down tester adapter into the
spark plug hole.
See Figure 2.1.
Figure 2.1
Leak-down tester
3. Connect tester to compressed air.
4. Adjust the regulator knob until the needle on the
gauge is in the yellow or set area of the gauge.
5. Connect the tester to the adapter.
NOTE: If the engine rotates it was not at top
dead center.
6. Check the reading on the gauge.
7. Compare the results to the following chart. See
Table 1.
Table 1:
Symptom Possible cause
Air escaping from
the breather
Worn cylinder or piston
rings. Possible blown
head gasket
Air escaping from
the exhaust
Leaking exhaust valve
Air escaping from
the carburetor
Leaking intake valve
Gauge reading low Cylinder and piston rigs
are in good condition
Gauge reading
moderate
There is some wear in
the engine, but it is still
usable
Gauge reading high excessive wear of cylin-
der and/or piston rings.
Engine should be short
blocked or it could be a
blown head gasket.
www.mymowerparts.com
For Discount White Outdoor Parts Call 606-678-9623 or 606-561-4983
To Next Page
Loading...
Need help?
General
