MTX MTX-3G-JAVA-IoT - 1.7.1 Key Features at a Glance

MTX-xG-JAVA-IoT Family
www.mtxm2m.com 2017/07 v1.2 Page 22/105
MTX M2M® by MATRIX ELECTRONICA S.L.U
RS232 (4-wire)
Adjustable baud rates: 1200bps to 921600bps
Autobauding: 1200 to 230400bps
Supports RTS/CTS hardware flow control
Multiplex ability according to GSM 07.10 Multiplexer Protocol
RS485
Adjustable baud rates: 1200bps to 921600bps
Autobauding: 1200 to 230400bps
Half-duplex
Opto I/O
2x inputs and 2x outputs optoisolated
ADC
2x analog inputs, supporting 0-50V modes (other modes available under request)
Count input
1x pulse count input
1-Wire
1-Wire (master) bus for EEPROM, Temperature sensors, etc.
CAN
Data rate up to 1Mbps
GIFT/ICT compliant
Status
Bi-color LED to indicate network connectivity status.
UICC interface
Supported chip cards: UICC/SIM/USIM 3V, 1.8V
Antenna
50 Ohms. GSM/UMTS main antenna
Power on/off, Reset
Power on/off
Automatic switch-on at power supply
Switch off by AT command
Switch off by hardware signal TURN_OFF
Automatic switch-off in case of critical temperature or voltage conditions
Software Reset
Orderly shutdown and reset by AT command
Hardware Reset
Emergency reset by hardware signal TURN_OFF
Special features
Antenna
SAIC (Single Antenna Interference Cancellation) / DARP (Downlink Advanced Receiver Performance)
Rx Diversity (receiver type 3i – 64-QAM) / MIMO