To Next Page
D
Daniel YoungAug 13, 2025
What to do if the PE653 Device appears to be ‘LOCKED UP’ in Multi Wave Control Systems?
- KKevin MartinezAug 13, 2025
If the PE653 device appears to be locked up, power down the PE653 device to reset it.
What to do if the PE653 Device appears to be ‘LOCKED UP’ in Multi Wave Control Systems?
If the PE653 device appears to be locked up, power down the PE653 device to reset it.
What to do if the Hand-Held Controller appears to be “LOCKED UP” in Multi Wave PE653RC Control Systems?
If the Hand-Held Controller appears to be locked up, power down the Controller to reset it.
What to do if the circuit breaker for the pump trips every time that the Pump turns ON in Multi Wave PE653RC?
If the circuit breaker for the pump trips each time the pump turns on, confirm that the system is programmed for a 2-speed pump, check the wiring for a 2-speed pump, and confirm that the controls in the heater are turned ON.
Why high speed and low speed circuits turn ON together when the pump is turned ON in Multi Wave PE653RC?
If both high and low speed circuits activate simultaneously when the pump is turned on, confirm that the system is programmed for a 2-speed pump. If needed, reprogram the system for 2-speed pump operation.
What to do if water or moisture is visible inside the screen of the Hand-Held Controller in Multi Wave PE653RC Control Systems?
If water or moisture is visible inside the screen of the Hand-Held Controller, dry out the Hand-Held Controller.
What to do if the 2-speed pump will not operate in 2-Speed mode in Multi Wave Control Systems?
If the 2-speed pump will not operate in 2-Speed mode, verify that all wiring connections are correct and secure, that the correct voltage is present at terminals 1 and 2 and that your system is configured for a 2-speed pump. For pump assistance, contact your pump service company.
Why the heater turns OFF but gets very hot after the pump turns OFF in Multi Wave PE653RC?
If the heater turns off but gets very hot after the pump turns off, verify that the heater has a proper “Time Interval” programmed for cool down.
What to do if the system appears to work, the LEDs turn ON and OFF but the power circuits and attached equipment will not turn ON in Multi Wave Control Systems?
If the system appears to work, the LEDs turn ON and OFF but the power circuits and attached equipment will not turn ON, verify that the voltage is correct at the PE653 power terminals.
Covers risks of injury, hyperthermia, and health considerations.
Addresses risks of electric shock and installation requirements.
Explains power connections and terminal assignments for the PE653.
Step-by-step guide for physically installing the PE653 enclosure.
Steps to establish communication between the controller and receiver.
Procedure to clear previous settings before setup.
Setting up multiple controllers for the system.
Clearing existing Z-Wave device programming before inclusion.
Connecting the PE953 to control a PE650 network.
Diagnosing issues where indicators work but equipment does not.
Details of the product's one-year limited warranty.
General| Brand | Multi Wave |
|---|---|
| Model | PE653RC |
| Category | Control Systems |
| Language | English |