Installation
Ultima Hooklift 01/2020
61
8. Finishing the installation
Protect all electric connections and check the greasing points.
Finish all welding and surfaces of the cut plate edges.
Clean all excess lubricants and remove all welding sparks and protection agents.
Wash the hooklift and other components thoroughly before touch-up painting.
As standard the hooklift is delivered from factory painted with 100 µm single layer polyurethane
top coat according to standard PUR 100/1 FeSa 2½. As an option the main frames are primer
painted with zinc primer before top coating according to standard EPZn®PUR 140/2 FeSa 2½.
Repair all possible damages in the painted surface immediately to avoid any corrosion:
Protect the surrounding area and clean the damaged area thoroughly from impurities and old
paint to clean steel surface. Smoothen the paint edges carefully. Check that the surface is
clean from dust, oil and grease and completely dry for the touch-up. Paint it with 100 µm layer,
use of primer is not recommended. Use acrylic paint with correct colour, check the tone and
code (RAL) carefully before painting. Let the paint dry 24 h indoors.
Check the correct colour from the hooklift order before touch-up painting.
If any accessories are installed afterwards to the hooklift frames, then use protective wax be-
tween the components.
NOTE! It is not allowed to paint the I/O module, radio receiver and gateway module.
9. User training
User training and service instructions must be given to the operators of the hooklift. Stress the
need to observe safety rules during operation.
Check that all required documents are made and filled as well as the operator’s manual is
available for the user.
Remember to fill the delivery card in C-Care to ensure that the product warranty takes
effect. Print a copy also to the customer.
To Next Page
Loading...