MultiOne SRL
Self-moving Compact wheel loader, articulated frame, equipped with
multipurpose quick coupler, MULTIONE 6 Series
Instruction manual (Translation of the original instructions)
CM150032EN - 16.06.15 - 05 (11.07.18)
46/76
FIG. 24
A B
C D
3
2
4
5
8.3.4.2 Mechanical connection of the attachment with hydraulic release system (option)
To carry out the assembly of the attachment, in case the machine is provided with a hydraulic release system, proceed as follows:
1) Make sure the attachment is positioned on firm and level ground.
2) Turn on the machine (see par. 8.3.2).
3) Push the multifunction joystick to the right in order to tilt forward the quick coupler of the machine. If necessary translate
backwards few cm.
4) Operating carefully draw up the quick coupler to one of the attachment so as to go up the upper round profile (FIG. 24 - Ref. 2)
in their curved seats of the (FIG. 24 - Ref. 1) attachment.
5) Press and hold the attachment release button
(TAB. 5 - Ref. 1) and at the same time activate the selector of the flow of
couplings in forward position (see par. 4.3.3).
6) Move the multifunction joystick to the left, in order to leans backward the quick coupler. Operating in this way the quick coupler
of the machine and the one of the attachment are aligned.
7) Release the attachment release button
(TAB. 5 - Ref. 1), in this way the two plugs of the coupler are lowered and inserted
in the fitted seats of the coupler of the attachment.
8) Lift the attachment and lean forward moving the multifunction joystick to the right to check visually that the two plugs of coupling
are correctly inserted in the fitted seats of the attachment. If not, relocate the attachment on the ground and repeat the procedure
from step 1).
8- OPERATION
To Next Page
Loading...
Need help?
General
