MultiOne 6 Series User Manual

Instruction manual (Translation of the original instructions)
CM150032EN - 16.06.15 - 05 (11.07.18)
51/76
Self-moving Compact wheel loader, articulated frame, equipped with
multipurpose quick coupler, MULTIONE 6 Series
MultiOne SRL
8.4 Functions/exceptional situations
8.4.1 Instability of the machine
It may happen that by performing a curve at high speed or by lifting a heavy load the machine is to be in a state of instability.
To avoid this situation proceed as follows:
1) Steer the machine only at low speed and with load as close as possible to the ground.
2) No extension of the lift arm when it is lifted and with lifted load (see par. 4.5.3).
3) Do not lift heavy loads by buckets or other attachment for lifting (see par. 4.5.3).
8.4.2 Overpressure in the hydraulic circuit
The machine is equipped with a system of hydraulic valves that limit the oil pressure within the circuit to avoid any damage.
In particular difficulty running it may happen to hear a hissing sound. This indicates that the valves were brought into service.
If the condition of effort should go on and this may result in damage so you will need to decrease the stress for the machine by
reducing the speed of work and/or the number of the engine rpm.
8.4.3 Loss of control
In case the amount of oil inside the hydraulic circuit decreases considerably due to a fault with relative loss it may happen that the
machine enters into neutral and loses the effect of “engine brake” given by the hydraulic circuit. In this condition the control of the
machine can be compromised. To avoid this situation proceed as follows:
1) Before any starting check the presence of possible loss.
2) Check the hydraulic oil level and if necessary top up (see chap. 9).
DANGER
IN CASE OF EMERGENCY SITUATION OPERATE THE PARKING BRAKE TO STOP THE MACHINE.
HYDRAULIC OIL UNDER PRESSURE CAN PENETRATE BODY TISSUE CAUSING SERIOUS INJURY AND POSSIBLE DEATH. WHEN
TROUBLESHOOTING A HYDRAULIC SYSTEM FOR LEAKS, ALWAYS USE CARDBOARD OR WOOD AS A DETECTOR. DO NOT USE
YOUR BARE HANDS.
8.4.4 Emergency exit of the cabin
In case of need to open the emergency door on the machines supplied with cabin proceed as follows:
1) Pull the red ring on the handle to open of the Right window of the machine (FIG. 30 - Ref. 1).
2) Push out the Right window to open fully.
8.4.5 Block of the machine with the lift arm raised
DANGER
ATTENTION: THIS IS AN EMERGENCY PROCEDURE AND THEREFORE THE AREA MUST BE CONTROLLED AND FORBIDDEN.
In case of malfunction of the machine which make it impossible to retract the lifting arm raised, it is not safe to lower it because
there would be a considerable imbalance of the machine. As it is a malfunctioning machine, the imbalance cannot be reduced by
retracting the arm and so the risk of rollover of the machine would be relevant and unmanageable.
To return the attachment and the eventual load on the ground proceed as follows:
1) Insert the parking brake.
2) Remove the key from the control panel.
3) Secure the area around the machine.
4) Using a special machine (eg. forklift) download the suspended load.
5) Lower the lifting arm.
OPERATION -8

MultiOne 6 Series Specifications

General

Brand	MultiOne
Model	6 Series
Category	Compact Loader
Language	English