15 of 20
04/23/2020
Subject: FreshBlender FAQ & Troubleshooting
No Water
• Confirm the water supply line is connected to the rear
of the unit, labeled plain water. Reconnect the line if
necessary. See FIGURE 1.
• Is quick connect properly seated and connected to back
of machine? See FIGURE 1.
• Verify water supply shutoff valve is open. See FIGURE 2.
• Are lines correctly connected to water filtration system?
See FIGURE 3.
• Do the water filtration filters need to be changed?
- Stores with hard water or high volume may need to
change filters more often.
• Water pressure too low, call for service.
NO WATER SPRAYED DURING THE RINSE CYCLE
Dispense Rinse Nozzle
• Clean nozzle.
• Green rinse solenoid stuck closed, call for service.
Blender Shaft Nozzle
• Clean nozzle.
• Black blend shaft solenoid stuck closed, call for service.
Blender Blade Nozzle
• Clean nozzle.
• Black blender blade solenoid stuck closed, call for
service.
FIGURE 1 -Verify water is connected
FIGURE 2 -Shutoff valve
CLOSED OPEN
FIGURE 3 -Water Filtration
Unfiltered
Water IN
Filtered
Water OUT
Filtered
Water IN
To Next Page
Loading...
