8 of 20
04/23/2020
Subject: FreshBlender FAQ & Troubleshooting
How to Roll Product Bag
1. Unlock unit and open lower refrigerated cabinet.
2. Push latch down off pump, hold clean towels under
pump to prevent product spills and slowly pull bin out
to access product bag.
3. With product pump still snapped into bin, lift opposite
end of product bag and gently push product down
towards pump end.
4. Twist or roll bag to keep product at pump end and then
fold empty part of bag under end of bag that contains
product.
5. Carefully push bin back into refrigerated cabinet and
latch into place.
6. Do not force the latch over the pump, if the latch
does not snap into place adjust the motor shaft until
the pump properly seats on the sanitation fitting and
latches easily.
7. Close and lock door.
FIGURE 1 - Lift and push product towards pump end.
FIGURE 2 - Twist or roll bag and tuck under.
To Next Page
Loading...
Need help?
General
