Multiplex FreshBlender User Manual

Part Number: WBL-95-156 REV002 37
General Maintenance
This section covers common unit components and their care.
The chart below is an overview of the maintenance that
the end user and service technician should perform, and
the frequency. These figures are the minimum required. If
the Ice Machine is supplied with hard water, more frequent
cleaning should be performed. If the condenser air filter is
totally blocked after one week, more frequent cleaning is
recommended. (X = End User, S = Service Company)
Maintenance Daily Weekly Monthly 3 Months 6 Months Annual After Prolonged
Shutdown
At Start-Up
Blender / Dispense Area
Cleaning/ Sanitizing
(Zone 1 Cleaning)
X
Product Line Cleaning &
Sanitizing
(Zone 2 Cleaning)
X X S
Drain Cleaning X X X
Clean Air Filters X X
Clean/Sanitize Ice
Maker/Bin
(Zone 3 Cleaning)
S X
Descale IceMaker/Bin
(Zone 3 Cleaning)
S S
Clean Condenser Coil X X
Inspect Ice Maker /
Dispenser Parts
S X S
Check Ice Quality X X S S S
n
Warning
The power switch must be turned to OFF and the
unit disconnected from the power source whenever
performing service, maintenance functions or cleaning
the refrigerated area
Important
If the machine going to be shut down for any length
of time, it is recommended to go through the Zone 2 -
Weekly Cleaning both prior to turning off the unit and
when returned to use.
If the unit is turned off, the product will no longer
be kept cool in the refrigeration cabinet. Remove all
product bags and keep refrigerated to prevent spoilage.
DOOR GASKET MAINTENANCE
Door gaskets require regular cleaning to prevent mold and
mildew buildup and also to retain the elasticity of the gasket.
Gasket cleaning can be done with the use of warm soapy water.
Avoid full strength cleaning products on gaskets as this can cause
them to become brittle and crack. Never use sharp tools or knives
to scrape or clean the gasket. Gaskets can be easily replaced and
do not require the use of tools or an authorized service person.
The gaskets are “Dart” style and can be pulled out of the groove in
the door and new gaskets can be “pressed” back into place.
DRAIN MAINTENANCE  INSIDE LOWER CABINET
Each unit has a drain located inside the unit that removes the
condensation from the evaporator coil and routes it to an
external condensate evaporator pan. Each drain can become
loose or disconnected during normal use. If you notice water
accumulation on the inside of the unit, be sure the drain tube
is connected to the evaporator drain pan. If water is collecting
underneath the unit, make sure the end of the drain tube is in
the condensate evaporator in the machine compartment. The
leveling of the unit is important, as the units are designed to drain
properly when level. Be sure all drain lines are free of obstructions.
Section 4
Maintenance

Multiplex FreshBlender Specifications

General

Brand	Multiplex
Model	FreshBlender
Category	Dispenser
Language	English