Multiplex FreshBlender User Manual

Part Number: WBL-95-156 REV002 65
Section 4 Maintenance
ICE MACHINE DESCALING & SANITIZING
To be done every six (6) months.
Descaling
Important
Only a trained manager or authorized technician should
perform ice machine sanitizing.
n
Warning
Always wear liquid-proof gloves to prevent the descaling
and sanitizing solutions from coming into contact with skin.
1. Disconnect the water supply line quick connect in the
back of the unit.
2. Remove the left side and top panels from the unit to
gain access to the reservoir, ice dispense motor, and bin.
3. Evacuate all water from the reservoir and evaporator by
entering the Service screen> Service Outputs> Cleaning
and toggling the Ice Maker Dump Valve ON until all water
has been emptied from the system then toggle OFF.
4. Mix approved descaling solution ratio noted.
Amount of Luke Warm
Water
Amount of Ice Machine Cleaner
5 gallons (20 Liters) Use approved ice machine cleaner.
Consult manufacturer’s instructions
for ratio to make up 1 container of
solution.
NOTE: For safety and maximum effectiveness, use the
solution immediately after dilution
5. Remove top cover from the water reservoir, fill the evaporator
and reservoir with solution. Remainder of solution will be
used for manual descaling of other parts.
6. Reconnect power and turn the power rocker switch to the
ON position.
7. Leave the descaler in the system for 15 minutes and perform
the following procedures during the 15 minute period:
• Descale drain by gently flexing to remove any scale
residue.
• Inspect water feed and drain lines and clean as needed.
8. Evacuate all solution from the reservoir and evaporator
by entering the Service screen> Service Outputs>
Cleaning and toggling the Ice Maker Dump Valve ON
until all solution has been emptied from the system then
toggle OFF.
9. Using a pitcher, fill and drain the evaporator/reservoir four (4)
times.
10. Set the power rocker switch on the top right of the unit
to the OFF position, disconnect power.
11. Remove ice dispense motor assembly by removing six
(6) thumbscrews.
12. Remove ice bin cover.
13. Remove any ice in the bin manually.
14. Remove ice agitator. Descale, rinse and sanitize the
ice agitator.
15. Remove the dispense wheel assembly.
16. Soak the following parts for 20 minutes in descaling
solution, then rinse thoroughly:
• Dispense Wheel
• Housing
17. Use an approved sanitizing solution ratio noted.
Amount of Luke Warm
Water
Amount of Sanitizer
5 gallons (20 Liters) Use approved QUAT (Quaternary
Ammonium) sanitizer solution providing
300 ppm minimum or solution that
provides 100 ppm available Chlorine
minimum. Consult manufacturer’s
instructions for ratio or 1/4 ounce (15 ml)
household bleach per gallon
18. Soak the removed parts in sanitizing solution for 10
minutes and wipe them down.
n
Warning
If solution is left on these parts, they will rust.

Multiplex FreshBlender Specifications

General

Brand	Multiplex
Model	FreshBlender
Category	Dispenser
Language	English