60 Part Number: WBL-95-156 REV002
Maintenance Section 4
Weekly Cleaning Complete
1. Weekly cleaning has been completed.
2. Unit will need to be cleaned again in 7 days.
3. Return supplies to cleaning kit.
4. Ensure top and bottom doors are closed and locked
5. Press Confirm button.
By pressing Confirm button, the weekly cleaning has been
completed and the weekly timer has been reset for 7 days
Monthly Tasks
Cleaning the Condenser Coil
In order to maintain proper refrigeration performance, the
condenser fins must be cleaned of dust, dirt and grease
regularly. It is recommended that this be done at least every
three months. If conditions are such that the condenser is
totally blocked in three months, the frequency of cleaning
should be increased. Clean the condenser with a vacuum
cleaner or stiff brush. If extremely dirty, a commercially
available condenser cleaner may be required.
Failure to maintain a clean condenser coil can initially cause
high temperatures and excessive run times. Continuous
operation with a dirty or clogged condenser coil can
result in compressor failure. Neglecting the condenser coil
cleaning procedures will void any warranties associated
with the compressor and cost to replace the compressor.
,
Caution
Never use a high-pressure water wash for this cleaning
procedure as water can damage the electrical
components located near or at the condenser coil.
Exterior Cleaning
Remove dust and dirt from the exterior surfaces with a mild
household dish washing detergent and warm water. Wipe
dry with a clean, soft cloth.
Never use steel wool or abrasive pads. They will scratch the panels.
Plastic exterior panels and UI (User Interface) Screen should
be cleaned with a mild household dish washing detergent
and warm water on a damp cloth. Wipe dry with a clean lint
free cloth. DO NOT saturate the screen or other electrical
components with water or other cleaning agents.
To Next Page
Loading...
Need help?
General
