38 Part Number: WBL-95-156 REV002
Maintenance Section 4
REFRIGERATOR
n
Warning
Do not damage the refrigeration circuit when installing,
maintaining or servicing the unit.
The interior and exterior can be cleaned using soap and
warm water. If this isn’t sufficient, try ammonia and water
or a nonabrasive liquid cleaner. When cleaning the exterior,
always rub with the “grain” of the stainless steel to avoid
marring the finish. Do not use an abrasive cleaner because
it will scratch the stainless steel and can damage the
breaker strips and gaskets.
CARE & CLEANING
n
Warning
Never Use Steel Pads, Wire Brushes or Scrapers!
,
Caution
Never use an acid-based cleaning solution! Many food
products have an acidic content, which can deteriorate
the finish. Be sure to clean the stainless steel surfaces of
ALL food products. Common items include: tomatoes,
peppers and other vegetables.
DOORS/HINGES
Over time and with heavy use, doors and hinges may
become loose. If this happens, tighten the screws that
mount the hinge brackets to the frame of the unit. Loose
or sagging doors can cause the hinges to pull out of the
frame, which may damage both the doors and the hinges.
In some cases this may require qualified service agents or
maintenance personnel to perform repairs.
NOTE: Do not place hot pans on/against the blue ABS liner.
Do not throw items into the storage area. Failure to follow
these recommendations could result in damage to the
interior of the cabinet or to the blower coil. Overloading
the storage area, restricting the airflow, and continuous
opening and closing of the doors and drawers will hamper
the unit’s ability to maintain operational temperature.
PREVENTING BLOWER COIL CORROSION
Immediately wipe up all spills.