MT CELL SETUP MANUAL MT556XNB, MT556UNB AND MT557D | 27
6 CONNECT THE CELL
Revision 3.0 www.multitaction.com
15.9.2020
P/N: MT2201012
6 Connect the Cell
The Cell connection panel is located at the back of the device; see section 2.3.
Warning: People can trip over loose and hanging cables, causing personal injuries and damage
to the Cell. Route and fasten all cables out of the way.
Avertissement: Les gens peuvent se trébucher sur des câbles non fixés ou pendants, ce qui peut
causer des dommages personnels ou endommager la Cellule. Acheminer et fixer tous les câbles
à l’écart.
6.1 Connections to the mains power supply
To protect Cells from voltage spikes, we recommend that you:
Warning: Always connect Cells to the mains power supply using a 3-wire cord and power strip
with a protective earth. Failure to do so may cause an electric shock when using the Cell!
Avertissement: Toujours brancher les Cellules sur le bloc d’alimentation électrique à
l’aide du cordon à 3 fils et de la multiprise avec un conducteur de protection. Tout
manquement peut provoquer un choc électrique en utilisant la Cellule!
When connecting other equipment to the Cell, make sure all equipment is disconnected from
the mains. Failure to do so may damage the Cell through ground leakage currents from and to
other devices.
Do not connect more than two Cells to a single power strip when connecting them to the
mains power supply.
Power up the Cells one at a time in multiple-Cell installations.
For Cell power consumption details, see section A4. Electrical Specifications
MT557D, MT556XNB and MT556UNB
Dual Ø5 x 20mm 6.3A 250VAC T (Time-Lag)
To Next Page
Loading...