3-14 LDAP server settings
Setting the default LDAP server
You can set the default LDAP server using the following procedure.
NOTE: At least one LDAP server should be registered.
1
Press [Setting] on the control panel.
2
Press [Management], [Network Settings], [LDAP Settings], and [LDAP Server
Setting] in this order.
NOTE: Once you have reached this display, refer to the steps 2 to 5 on pages 3-2 and
3-3.
3
Press [Default Server].
4
Select an LDAP server you want to set as the default server.
5
Press [Enter].
6
When you have finished press [Reset] on the control panel to return to the
Standby mode.
To Next Page
Loading...
Need help?
General
