TCP/IP settings
This machine uses TCP/IP protocol to communicate over the LAN, meaning the
TCP/IP settings described in this guide must be registered prior to using the
machine on the LAN.
NOTE: Contact your network administrator if you are unsure about these settings.
IMPORTANT: In order to activate new settings, the machine must be rebooted after the new
settings have been entered. Turn the machine “Off” and after three or more
seconds, turn the machine back “On”.
Opening the TCP/IP setting menu display
1
Press [Setting] on the control panel.
2
Press [Management].
3
Press [Network Settings].
To Next Page
Loading...
