Muratec MFX-2030 - LDAP Server Settings; Printing the LDAP Parameter Setting

3-18 LDAP server settings
6
When you have finished press [Reset] on the control panel to return to the
Standby mode.
NOTE:
You can register up to two attributes for each search object.
When two attributes have been registered, the attribute 1 (ex. “cn”) is used
for search filter. And then, the machine will retrieve the records that include
the registered attributes you set.
For example, when the LDAP parameters are set as follows, and you entered
a name for object search, the machine first requests the LDAP server to
search the record that includes “cn=(text you’ve entered)”. Then, the machine
retrieves the parameters based on all the registered attributes (cn, common-
name, mail, facsimiletelephonenumber, telephonenumber, o, ou) from the
searched records.
Name1 : cn
Name2 : commonname
Mail1 : mail
Mail2 :
Fax1 : facsimiletelephonenumber
Fax2 :
Tel1 : telephonenumber
Tel2 :
Dept.1 : o
Dept.2 : ou
Printing the LDAP parameter setting
Print the “Network Settings” list (refer to page 7-2) and view the “LDAP Parameter
Settings” that are underneath the heading “LDAP Settings”.