To Next Page

To Previous Page

Section 40 00-02-0716

2013-06-03 - 9 -

Use the following steps to select the correct start/stop:

1. Access the S numbers menu by pressing [Menu].

2. Use the [Up Arrow] and [Down Arrow] to scroll to the correct Entry Code (See Entry Code

Supplement for Entry Codes).

3. When the correct Entry Code is displayed, press [Enter] to access the S numbers menu.

NOTE: If the incorrect code is entered, “PASSWORD FAILURE” will appear on

the display. Press [Enter] and try again.

NOTE: S35 is the S-Number used for the start/stop type. See the S number

section of this manual for details.

4. Press the [Up Arrow] and [Down Arrow] until (S35) START/STOP SELECT is displayed,

press [Enter] to highlight the current setting.

5. Press the [Up Arrow] and [Down Arrow] until the desired selection is displayed, press

[Enter] to un-highlight the new setting.

6. Exit the S Menu by pressing [Menu].

System Throttling Types

There are (3) throttling types in S37: MAX. RPM, TRANSDUCER, LOCAL THROTTLE.

Max. RPM:

The Engine is throttled to the max. rpm set point.

Transducer:

A transducer is used for auto throttling. There are set points, allowing the operator to enter the

appropriate values.

Local Throttle:

An external 0-5 vdc potentiometer is used for auto throttling. There are set points, allowing the operator

to enter the appropriate values.

Use the following steps to select the correct transducer type: