Section 40 00-02-0716
2013-06-03 - 1 -
Introduction
This document is designed to support a user in getting familiar with the EMS PRO and how to navigate
the interface, modify the settings and install and operate the controller. The Quick Set Up guide assists
with establishing the different functions in the EMS PRO System Controller. Before attempting to set
up the controller, be sure to read and understand this manual in its entirety.
Product Description
The EMS PRO is a flexible, all-in-one customizable unit that meets the needs of engine-driven pumping
equipment applications. The EMS PRO is a dedicated microprocessor-based, single-engine controller.
It offers field-adjustable operating parameters that can be changed without the need for a laptop
computer. It is able to support both mechanical and J1939 electronic engines.
The EMS PRO has a selectable auto start/stop with many auto throttling options. The auto start/stop
options (Single Contact, Floats, Momentary, and Transducer) are available at the touch of a button. In
addition, there are many performance-enhancing features, all of which are available via a back-lit
operator interface that’s easy to learn and use. The display is readable day or night.
The EMS PRO is designed for use with a SCADA system, offering Modbus® RTU protocol on either the
RS232 or RS485 port. See the Modbus portion of this manual for details.
NOTE: Harness kit 40000536 is available to “bring out” the (2) wire RS485 to the
bottom of the enclosure. The RS232 is accessed via a DB9 connector located on
the display/CPU board. Customer modification to the enclosure is required to use
either port.
To Next Page
Loading...
Need help?
General
