Murphy EMS PRO - ENTRY CODE SUPPLEMENT; P-NUMBERS Entry Code; S-NUMBERS Entry Code

Section 40 00-02-0716
2013-06-03 - 38 -
REGISTER
#
TYPE DESCRIPTION
40042
Read / Write
Stop Level. Factory set to 5.0 feet.
40043
Read / Write
Maintain Level. Factory set to 10.0 feet.
40044
Read / Write
Stop Flow. Factory set to 1000 GPM.
40045
Read / Write
Maintain Flow. Factory set to 5000 GPM.
ENTRY CODE SUPPLEMENT
WARNING
Knowledge of these codes allows you to set the operating parameters of the controller. You can
customize the operation to fit your specific application. Keep this number unknown to anyone you do
not want to have access to this customization.
P-NUMBERS
The P-numbers contain clock functions and the shutdown history. The code number is 61.
S-NUMBERS
The S-numbers contain critical information and control functions. Be sure that only qualified personnel
have access to this entry code. The code number is 64.
LOADING PROGRAM
If a new program is needed, always perform a factory setup after loading into the EMS PRO.