In order to consistently bring you the highest quality, full featured products, we reserve the right to change our
specifications and designs at any time.
ENOVATION CONTROLS has made efforts to ensure the reliability of the EMS PRO
and to recommend safe use practices in system applications. Please note that in any
application, operation and controller failures can occur. These failures might result in
full control outputs or other outputs that might cause damage to or unsafe conditions
in the equipment or process connected to the EMS PRO.
Good engineering practices, electrical codes, and insurance regulations require that
you use independent external protective devices to prevent potentially dangerous or
unsafe conditions. Assume that the EMS PRO can fail with outputs full ON, outputs
full OFF or that other unexpected conditions can occur.
Please read the following information before installing.
BEFORE BEGINNING INSTALLATION OF THIS MURPHY
PRODUCT:
• This installation information is intended for all EMS PRO Series models. A visual
inspection of this product before installation for any damage during shipping is
recommended.
• Disconnect all electrical power to the machine. Failure to disconnect all electrical
power connections before welding can result in damage to the panel and/or its
components.
• It is your responsibility to have a qualified technician install the unit and make sure
installation confirms with local codes.
• Observe all Warnings and Cautions in each section of these instructions.
• The EMS PRO is designed for use in industrial environments. There might be
potential difficulties in ensuring electromagnetic compatibility in other
environments due to conducted as well as radiated disturbances.
• Please contact ENOVATION CONTROLS immediately if you have any questions.
IMPORTANT! False or improper use and operation of electronic
products could be dangerous. It is required that point-of-operation
guarding devices be installed and maintained. All such devices must
meet OSHA and ANSI Machine safety standards. The manufacturer shall
not accept any responsibility for installation, application or safety of
To Next Page
Loading...
Need help?
General
