User Manual of VT1000
- 32 -
Configure
SMS for the
extended
photoing
parameters
W<password>,108,ABCDEFGHIJ###
Example: W000000,108,1000000000###
It means when In1 (SOS) alarm triggered,
it will automatic snap.
means snap, E=0 means no action
F: Snap or not when over speed alarm triggered,
F=1 means snap, F=0 means no action
G: Snap or not when movement alarm triggered,
G=1 means snap, G=0 means no actions
H: Snap or not when Geo-fencing alarm triggered,
H=1 means snap, H=0 means no actions
I: Snap or not when power fail alert triggered, I=1
means snap, I=0 means no actions
J: Snap or not when Oil/fuel leakage alarm
triggered, J=1 means snap, J=0 means no actions
The system all default is 0 , no actions.
By send
SMS to Roll
call take
photos:
W<password>,051
Camera failure alarm: when cannot snap photo, it will send SMS “ CAMERA ERROR ALARM!”
to SOS number, and send alarm data to platform as well.
(You can check photos on platform, Report Centre)
2.2 Configure tracker to set take photos
Open GPS tracker parameter editor (2010) V2.65 (following picture)
In photo enable option, choose you want to select the function.
Such as select IN1 alarm, means when trigger IN1 alarm (SOS alarm), tracker will automatic
snap photo.
To Next Page
Loading...