User Manual of VT1000
- 35 -
RFID function, and if send the enable SMS command the RFID function will be restored.
2.1.4 Judge if need to cut off oil/fuel supply when the ignition alert occurs to stop engine start.
Enable function of cutting off oil-way when illegally ignite under ARM status
SMS command: W<password>,061,1
Disable function of cutting off oil-way when illegally ignite under ARM status
SMS command: W<password>,061,0
The system default setting is disable function of cutting off oil-way when illegally igniting under
ARM status.
3. Command List
Description Command Reply SMS
Configure authorized RFID
tag
W<password>,060,num1
W<password>,160,num2
W<password>,260,num3
W<password>,360,num4
W<password>,460,num5
STUDY ID OK: 1:num1;
2:num2; 3:num3; 4:num4;
5:num5
Enable the RFID detection
W<password>,062,1
ENABLE OK !
Disable the RFID detection
W<password>,062,0
DISABLE OK !
Arm
<password>ARM
Vehicle is armed!
Disarm
<password>DSM
Enable function of cutting off
oil-way when illegally ignite
under ARM status
W<password>,061,1
Disable function of cutting off
oil-way when illegally ignite
under ARM status
W<password>,061,0
System default setting is
disable function of cutting off
oil-way when illegally ignite
under ARM status.
4. Functions
4.1 To ignite in Armed status, it will check the RFID tag. If an authorized tag can be detected, it
will not alert. If an authorized tag can not be detected, it will send alert SMS “Engine Is On !” to
three authorized alert mobile phone numbers, and at the same time, the Output 3 will control siren
to sound, and call the three mobile phones at one minute interval, and decide to cut off the oil/fuel
supply according to its oil cut enable/disable status.
4.2 If vehicle door is opened in armed status, it will check the RFID tag. If an authorized tag
can be detected, it will not alert; if an authorized tag can not be detected, it will send alert SMS
“Door Is Open !” to three authorized alert mobile phone numbers, and the Output 3 will control
the siren to sound, and call the three mobile phone numbers at one minute interval.
4.3 If the vehicle is moved/towed in armed status, it will detect the RFID tag, if no authorized tag
be detected, it will send alert SMS ”Movement alarm!” to the 1
st
alert mobile phone number.
4.4 In disarmed status, if no authorized RFID tag Is detected for successive 30 seconds, then the
system will automatically arm the vehicle, and it will call the 1
st
alert mobile phone number, after
To Next Page
Loading...