Unpacking 5
Install the product in an environment that satisfies the conditions in the table below.
Installation environment conditions
Power supply
specifications
Voltage AC 100 V to 120 V ±10 % or 200 V to 240 V ±10 %
Frequency 50/60 Hz ±1 Hz
Capacity No less than 10 A
Environmental
conditions
Operating environment Temperature 20 to 32 °C, humidity 40 to 60 %,
no condensation.
Ranges to ensure printing
precision
Temperature 22 to 30 °C, humidity 40 to 60 %,
no condensation.
Environment for storage • If not charged with ink when stored: up to 6 months
Temperature -20 to +60 °C, humidity 20 to 80 %.
• If charged with ink when stored: up to 1 week*
Temperature -10 to +40 °C, humidity 20 to 80 %.
*Up to 4 days if the ambient temperature is 32 °C or higher.
Cautions in using this product
When opening and closing the front cover
Do not open or close the front cover if you are not in a balanced posture.
If you open or close it in an unbalanced posture, your hands or other body parts could get caught in
it, possibly resulting in serious injury.
• Always close the front cover fully.
If you leave it part-open, it could close suddenly.
• When closing the front cover, always use both hands and hold it by the portions specified.
Do not place your fingers on the edges of the printer's opening portion, or on any parts around those edges.
Your fingers could get caught and be injured.
Always hold the cover by the places shown in the picture, using both
hands, and close it slowly.
WARNING
CAUTION
To Next Page
Loading...
Need help?
General