18 Using the Setup Wizard
2 Using the Setup Wizard
The accessory software CD has the following functions.
• It displays the procedure for setting up the printer, on the computer screen (Set-up Wizard function).
• It installs the following software and data to the computer (combined installation function).
(The manuals will not be installed by the integrated installer function.)
Insert the software CD
ValueJet Finder (VJ Finder) Sets an IP address for the printer, so that it can communicate with the computer.
Printer driver Needed for sending data from the computer to the printer. Also used for changing
the print settings and at certain other times.
ValueJet Status Monitor (VSM) Monitors the printer’s status information, and is able to alter various settings. Also
able to carry out initial ink charging and test printing.
ValueJet Layer Editor This enhances the printer driver's layer printing capability.
Manuals (for printer and software)
See
"Accessing the Manuals" P.29 for how to access the manuals.
The following manuals are available. They are in pdf format.
• VJ-426UF Operation manual “Operations and Maintenance Methods”
• VJ-426UF Driver User's Guide
• ValueJet LayerEditor Operation manual
• ValueJet Status Monitor Operation manual
• ValueJet Status Monitor Installation wizard Operation manual
• VJ-426UF Startup Guide (This manual)
[1]
Insert the accessory CD into the computer’s CD-ROM drive.
Note
• The Set-up Wizard will start up automatically.
• If the set-up wizard does not automatically start, right click the icon of CD-
ROM drive, open the contents of CD with [Open], and double click
VjTotalInst.exe.
[2]
Carry out set-up by following the instructions on the Set-up Wizard screen.
• When setup is complete, carry out test printing.
"Test printing" P.20
• When you have finished, do NOT turn the power off. Instead, use the sleep mode.
"Sleep Mode" P.28
Using the Setup Wizard
To Next Page
Loading...
Need help?
General