Setup via the control panel 13
2 Setup via the control panel
This printer requires activation when the power is turned ON for the first time.
Step 1 Carrying out activation
When the message on the left appears, carry out activation.
There are two ways of carrying out activation.
"To activate via the control panel:" P.13 below
"To activate via the internet:" P.13 below
To activate via the control panel:
[1]
Press the [Enter] key when the message on the left appears.
[2]
Enter a 16-digit activation code.
• Use the [+] key to increase a setting value.
• Use the [ - ] key to decrease a setting value.
• Press the [Enter] key to confirm. The cursor will move on to the next.
• Confirm your input for each value.
Note
Obtain the activation code from the distributor, by email or other means.
[3]
• When the message on the left appears, turn the power button off.
• Wait a short while, then turn the power button on, to restart the
printer.
To activate via the internet:
When the message on the left appears, carry out activation according
to the “Printer Activation Guide”.
Note
You can obtain the “Printer Activation Guide” by accessing the ValueJet Club via the
internet address below and registering as a user under “Register”.
https://valuejetclub.mutoh.co.jp/mutoh/guser/
Setup via the control panel
Activation required
Activation required
0 0 0 0 - 0 0 0 0 - 0 0 0 0 - 0 0 0 0
Reboot a printer
Activation required
To Next Page
Loading...
Need help?
General