+44 (0)23 8052 2345
22
MV Heating UK Ltd
Stand pipe 2: (Part No: AHZ-035) Figure XX
Supplied mainly in vehicle kits, this standpipe is installed like so:
• If possible; remove the sender unit from the vehicle’s fuel tank, this
will make it easier to attach the nut securely back onto the standpipe
• Drill a Φ6 ± 0.2mm hole into the sender unit
• Remove the nut from the standpipe and feed it through the hole
ensuring the rubber ‘o’ ring remains on the standpipe ‘head’ side
• Replace the nut on the standpipe to secure it safely to the sender
unit.
• Replace the sender unit into the fuel tank.
The bottom of the fuel standpipe should be 30-40mm from the bottom of the
fuel tank to allow enough suction of fuel and at the same time not allow
impurities and sediment to be drawn up the standpipe.
To Next Page
Loading...
