Page 40
5-4 Game Initialization
• Be sure to perform the following initialization process before the game is
played for the first time, and after replacing the Game PC Board, Steering
Assy Potentiometer, Accelerator/Brake pedal potentiometers, or after
initializing the backup data. The game will not play properly without
executing the initialization.
• After initializing potentiometers, conduct a switch test (see 6-2-4-2(b) page
50) to ensure that “OK” is shown when the steering wheel, accelerator
pedal or, or brake pedal are operated.
1. While pressing the Service button, press the Test switch. The following screen is
displayed.
2. Ensure that the steering wheel is in the centre position. Remove your hands from
the steering wheel, and ensure that your feet are removed from the accelerator
and brake pedals. (Initialization will not be completed correctly if the steering
wheel or accelerator/brake pedal is operated).
3. With the steering wheel and pedals as described above, press the Service
switch. The potentiometers will be initialized.
4. After the initialization, the screen for the switch test (see 6-2-4-2(b) page 50)
appears. Turn the steering wheel fully to the right and then to the left, and make
sure that “RIGHT OK” and “LEFT OK” is displayed on the screen.
5. Fully depress the accelerator and brake pedals, and make sure that “OK” is
displayed for both pedals.
6. Press and hold the Service switch, and press the Test switch to return to the I/O
test screen.
GO TO [SWITCH TEST]
I/O TEST
I/F INITIALIZE
STEERING +000
GAS 000
BRAKE 000
KEEP HANDLEBAR CENTER AND
PRESS SERVICE TO STORE THE RESULT
To Next Page
Loading...
Need help?
General
