Page 32
5. INSTALLATION
Notes on Installation
WARNING • NEVER turn the power to the machine ON until
installation has been completed.
WARNING • In order to prevent possible electric shocks, be sure
that the machine is connected to the mains with a
securely connected earthed plug.
WARNING • So that customers are not injured , ensure that there is
at least 500mm separation between other machines or
walls.
CAUTION • In order to avoid damage to the machine due to mis-
operation, ensure that the voltage of the mains supply is
230volts AC.
NOTE • If the location site of this machine has a polished floor it is
recommended that rubber pads are fitted under the level
adjusters to prevent the machine sliding on the floor.
• In order to gain access to the Power Supply and CPU
assemblies, make sure that the rear of the machine is
separated from a wall or other machine by at least 500mm.
• When installation is complete, it is imperative that the game
is initialized. (See section 7 page 57)
This machine is fitted with castors to make it easier to move. Take care
when moving the machine on an inclined surface.
The overall height of this machine is 1990mm. Take care of any
overhead obstructions. (e.g. Light Fittings, Electric Cables etc.)
When moving the game , ensure that the game is dis-assembled into 4
parts: Monitor Cabinet, Header Assembly and Seat Assemblies.
4. MOVING THE MACHINE
To Next Page
Loading...
Need help?
General
