X GEM-P1664 Programming Instructions
L NAPCO Security Systems
Page 12
WI1423A 1/06
GEM-RP2ASe2/GEM-K2AS--Easy Menu Driven Program Mode
EXIT DEALER PROGRAM MODE: This completes the custom default program. Press the C button to enter the Direct
Address Program Mode for further programming or press
C once again to end all programming and resume normal keypad
operation.
Clear Dealer Program (Erases Dealer Program)
This erases the dealer program. Use this feature to start a customized default program. Program
Data and System Status Memory is erased where Scheduled Data and Zone Descriptions are
maintained.
Access address 2285, then press the
U button. Data entry is not allowed. NOTE: Enter Easy Menu
Driven Program Mode to program system again.
Cold Start (Erases Entire Program)
This erases the entire program including Dealer Program by erasing Program Data, Zone Description
Data and System Status Data (similar to a new panel).
Access address 2286, then press the
U button. Data entry is not allowed. NOTE: Some features
(schedules) can only be programmed again with the Downloading Software.
(Direct Entry)
2285 XX
(Direct Entry)
2286 XX
CLEAR PROGRAM: Should it be necessary to create a new custom default program, (a) from the Dealer Program Mode, press
C to enter the Address Program Mode; (b) access Location 2285 (Clear Program) or 2286 (Cold Start); (c) press U and then
(d) press
C to exit the Dealer Program Mode. A “SYSTEM TROUBLE/E09-00 SERVICE” will occur. Press C to silence the
keypad.
To Next Page
Loading...
Need help?
General
