L NAPCO Security Systems
X GEM-P1664 Programming Instructions
Page 19
WI1423A 1/06
Dealer Code
Directly enter the Dealer Code, including leading zeros. Use the 1 through 9 buttons.
NOTE: Press
0 for a zero. Press U to save.
Re-enter the Dealer Code to verify the previous code. Press
U to save. Press the NEXT/YES
button to proceed. NOTE: The Dealer Code can be two or more digits (up to 6 digits).
CLEAR PROGRAM: Should it be necessary to create a new custom default program, (a) from the Dealer Program Mode, press
C to enter the Address Program Mode; (b) access Location 2285 (Clear Program) or 2286 (Cold Start); (c) press U and then
(d) press
C to exit the Dealer Program Mode. A System Trouble Condition will occur. Press C to silence the keypad.
(Direct Entry)
33
INTERIOR
BYPASS
FIRE/TBL SYS TBL CHIME
INTERIOR
BYPASS
FIRE/TBL SYS TBL
CHIME
rE
ZONE DESCRIPTIONS: GEM-K3DGTL cannot be used to enter Zone Descriptions. To enter Zone Descriptions, you must use the GEM-K1CA
Keypad or the Napco Quickloader Software.
DATE ENTRY: GEM-K3DGTL cannot be used to enter the date. To enter Date, you must use the GEM-K1CA Keypad (Version 5 or later) or the
Napco Quickloader Software.
TIME ENTRY: GEM-K3DGTL cannot be used to enter the time. To enter Time, you must use the GEM-K1CA Keypad (Version 5 or later) or the
Napco Quickloader Software.
EXIT DEALER PROGRAM MODE: This completes the custom default program. Press C to enter the Direct Address
Program Mode for further programming or press
C once again to end all programming and resume normal keypad operation.
GEM-RP3DGTL/GEM-K3DGTL AND GEM-RP4RFC/GEM-K4RF Easy Menu Driven Program Mode
To Next Page
Loading...
Need help?
General
