THIS MANUAL INCLUDES FEATURES WHICH ARE ONLY AVAILABLE IN
CONTROL PANEL FIRMWARE VERSION 01 OR LATER.
NAPCO Security Systems, Inc.
333 Bayview Avenue, Amityville, New York 11701
For Sales and Repairs, call toll free: (800) 645-9445
For direct line to Technical Service, call toll free: (800) 645-9440
Internet: http://www.napcosecurity.com
IMPORTANT NOTE
This manual supports the keypad programming of the GEM-P1664 control panel with the NAPCO "classic" GEM-
RP2ASe2, GEM-RP3DGTL and GEM-RP4RFC series keypads as well as the GEM-K2AS, GEM-K3DGTL and GEM-
K4RF "K Series" keypads. The new "K Series" models offer the new STAY and AWAY buttons with simplified function-
ality, along with the new MENU and ENTER buttons. While the instructions in this manual are depicted using the "K Se-
ries" keypads, the manual applies to both the "classic" and the "K Series" keypads.
Program Mode
is the same for both keypads--only the button names have changed, as follows:
• The
A button and the R button operate identically (in Program Mode) for both keypads.
• The D button and the U button operate identically (in Program Mode) for both keypads.
• The
button and the button operate identically (in Program Mode) for both keypads. The words
"NEXT/YES button" are used in this manual.
• The
button and the button operate identically (in Program Mode) for both keypads. The words
"PRIOR/NO button" are used in this manual.
For consistency, it is recommended that all keypads either be all "classic" or all "K Series"--both keypad
types should not be used in one alarm system.
CHANGES FROM PREVIOUS EDITION
The following changes have been made to this manual (WI1423A) since the previous edition (WI1423):
Updated the Wiring Diagram, page 64.
To Next Page
Loading...
Need help?
General
