NARDA PMM 7010/00 - User Manual

NARDA
Safety
Test
Solutions
S.r.l. Socio Unico
Sales & Support:
Via Leonardo da Vinci, 21/23
20090 Segrate (MI) -
ITALY
Tel.: +39 02 2699871
Fax: +39 02 26998700
Manufacturing Plant:
Via Benessea, 29/B
17035 Cisano sul Neva (SV)
Tel.: +39 0182 58641
Fax: +39 0182 586400
http://www.narda-sts.it
SERIAL NUMBER OF THE INSTRUMENT
You can find the Serial Number on the rear panel of the instrument.
Serial Number is in the form: 0000X00000.
The first four digits and the letter are the Serial Number prefix, the last five digits are the
Serial Number suffix. The prefix is the same for identical instruments, it changes only
when a configuration change is made to the instrument.
The suffix is different for each instrument.
Document 7010EN-81007-1.09 – Copyright © NARDA 2018
User’s Manual
PMM 7010
EMI CISPR RECEIVER
- PMM 7010/00 EMI CISPR Receiver
150 kHz ÷ 1000 MHz Pre compliance
- PMM 7010/01 EMI CISPR Receiver
9 kHz ÷ 1000 MHz Pre compliance
- PMM 7010/02 EMI CISPR Receiver
9 kHz ÷ 30 MHz Pre compliance
- PMM 7010/03 EMI CISPR Receiver
9 kHz ÷ 3000 MHz Pre compliance

Summary

Safety Recommendations and Instructions

General Information

Introduction to PMM 7010

Provides an overview of the PMM 7010 EMI receiver and its capabilities.

Main Specifications

Presents the key performance specifications and technical data of the PMM 7010.

Front Panel

Describes the connectors, controls, and indicators on the front panel of the PMM 7010.

Rear Panel

Details the connectors, labels, and switches on the rear panel of the PMM 7010.

Functional Description

Explains the receiver architecture and design philosophy of the PMM 7010.

Fast and Precise Measurement

Highlights the PMM 7010's ability to perform fast and accurate EMI measurements.

Emission Measurements

Discusses Electro Magnetic Interference (EMI) and the PMM 7010's role in measurements.

Installation

Power Supply

Details the universal adapter, voltage, and connector for the PMM 7010 power input.

Hardware Installation

Steps for connecting power and initial setup before operating the PMM 7010.

Using Artificial Mains Network

Describes connecting the PMM 7010 to LISNs for conducted interference measurements.

Operating Instructions

Operating Modes

Details the receiver's operation modes: Sweep, Analyzer, and Manual.

Detectors

Explains detector types like RMS-AVG, C-AVG, and Smart Detector.

Smart Detector

Explains the Smart Detector function for reducing test time and increasing productivity.

RBW Filters

Describes the selection of Resolution Bandwidth (RBW) filters and MIL filters.

Hold Time

Explains how to set the Hold Time for signal measurement and detector operation.

Applications

Measuring EMI Voltage

How to perform EMI voltage measurements using LISNs, probes, and antennas.

Test Setup Guidance

Provides step-by-step guidance for performing conducted EMI measurements.

Updating Firmware and Activation Code Utility

PMM 9010-RMA Rack Mount Adapter

Main Specifications

Rack Requirements

Installation Guidelines

Installing the PMM 9010-RMA

Step-by-step instructions for mounting the adapter into a 19-inch rack.

Using with PMM 9010

Procedure for installing the PMM 9010 or 7010 instrument into the adapter.

Remote Control

List of Commands

PMM 7010 Commands

Details query and setting commands to control operating modes and parameters.

NARDA PMM 7010/00 Specifications