To Next PageTo Next Page
Need help?Do you have a question about the NARDA PMM 9010 Series and is the answer not in the manual?
General| Battery Life | > 4 hours |
|---|---|
| Input Impedance | 50 Ohm |
| Display | LCD |
| Detectors | Peak, Average |
| Resolution Bandwidth | 200 Hz |
Details on enclosed documents, operating manual updates, and serial number variations.
Overview of the PMM 9010 EMI receiver, its capabilities, and design philosophy.
Lists of standard items, optional accessories, and other available accessories for the PMM 9010.
Performance specifications for the PMM 9010, including frequency range, accuracy, and input.
Description of the front and rear panel controls, connectors, and indicators of the PMM 9010.
Explanation of the PMM 9010's receiver architecture and its unique Ultra Fast FFT capability.
Discussion on EMI, standards, and the PMM 9010's role in emission measurement.
Guidance on inspection, unpacking, and safety preparation for PMM 9010 use.
Details on the battery charger, charging procedure, and battery status indications.
Specifies operating/storage limits and procedures for returning the instrument for service.
Instructions for hardware setup, power-on, and connecting LISNs, probes, and transducers.
Guidance on using Artificial Mains Networks (LISNs) and the Pulse Limiter for protection.
Description of the User Port and pin configurations for remote cables.
Operating the PMM 9010 as a scanning EMI receiver using Sweep Mode.
Operating the PMM 9010 as a Spectrum Analyzer for signal analysis.
Using Manual Mode for detailed, step-by-step signal investigation and parameter control.
Instructions for Amplitude Probability Distribution measurements.
Guide to using the Click Mode for fast, automatic discontinuous disturbance measurement.
Introduction to the PMM 9010F EMI receiver and its ultra-fast FFT capabilities.
Overview of extension units for PMM 9010, expanding frequency range up to 18 GHz.
Procedure for updating firmware and activating options using PC software.
Instructions for installing the PMM 9010 into a 19-inch rack.
Information on RMS-AVG and C-AVG detectors and their activation.
Details on enabling and using additional RBW filters, particularly for MIL-STD-461E.
Installation and operation guide for the Click4E Four Channels Click Meter Option.
Procedure for measuring the insertion loss of a LISN using the PMM 9010 receiver.
Procedure for connecting the PMM 9010 to a PC wirelessly via Bluetooth.
Details on RS232/USB communication, protocol, and command string format.
Comprehensive lists of Query and Setting commands for remote instrument control.
Specific query commands and replies for Analyzer mode parameters.
Description of setting commands for sweep control, modes, and basic parameters.
Details on sweep structure, command sequences, and data formatting for remote control.
Notes on programming differences and specific commands for the 9010F model.
Commands for managing the Analyzer Max-Hold function, including activation and pause.
