NARDA PMM 9010 Series User Manual

Remote control 14-3
14.6 List of
commands
Query COMMANDs
Syntax Function
?3PR*
Tells whether the apparatus is a PMM 9010/30P and in which mode
?AAT*
Requests the Attenuator status for Analyzer mode.
?ACE*
Requests the Center frequency for analyzer mode
?ADT*
Requests the detector used for Analyzer mode
?AHT*
Requests the Hold Time for Analyzer mode.
?AOP*
Requests the Stop frequency for analyzer mode
?APA*
Requests the Preamplifier status for Analyzer mode
?APS*
Requests the Preselector status for Analyzer mode
?ART*
Requests the Start frequency for analyzer mode
?ASP*
Requests the Span frequency for analyzer mode
?BAT*
Requests the battery voltage status.
?BCD*
Tells whether the Optic-Fibre Downconverter (3 GHz) is linked and ready
?CFA*
Sends back the ID of the conversion factor
?CKR*
Requests the complete record of a click Report
?CRA*
Tells whether RMS-AVG detector is available
?DET*
Reports the five detector for manual mode
?DMD*
Requests the status of demodulator.
?DMV*
Requests the volume of demodulator.
?DPY*
Sends back the bitmap of display hardcopy
?FSA*
Sends back a string expressing the number of Sweep Records available
?FSF n*
Requests the complete record
?IDN*
Requests model, release and date of firmware
?MAF*
Requests the tuning frequency for manual mode
?MAT*
Requests the Attenuator status for Manual mode
?MHF
Sends back a string expressing the Analyzer Max-Hold function STATUS
?MHP
Sends back a string expressing the Analyzer Max-Hold PAUSE Status
?MHT*
Requests the Hold Time for manual mode
?MIL*
Tells whether MIL Filters are available
?MPA*
Requests the Preamplifier status for Manual mode
?MPS*
Requests the Preselector status for Manual mode
?PLM*
Requests the Pulse Limiter status
?RBW*
Requests the selected RBW
?S/N*
Requests Serial Number internally stored by manufacturer
?SAT*
Requests the Attenuator status for Sweep mode
?SDT*
Requests the Detector used for Sweep mode
?SHT*
Requests the Hold Time for Sweep mode.
?SOP*
Requests the Stop frequency for Sweep mode
?SPA*
Requests the Preamplifier status for Sweep mode
?SPS*
Requests the Preselector status for Sweep mode
?SRT*
Requests the Start frequency for Sweep mode
?TAT*
Requests the MinAtt value
?TGF*
Requests the tuning frequency for the 9010 Built-In Generator
?TGL*
Requests the output level of 9010 Built-In Generator
?TGS*
Requests the 9010 Built-In Generator status
?TGT*
Requests the Tracking status of 9010 Built-In Generator
?UHT*
Requests the actual Hold Time currently or lastly used
?UPP*
Requests the status of input PINs of the User Port

NARDA PMM 9010 Series Specifications

General

Brand	NARDA
Model	PMM 9010 Series
Category	Receiver
Language	English