NARDA PMM 9010 Series - A-A.5 Sweep Mode; A-A.5.1 Detector Selection

A-A-4 RMS-AVG and C-AVG Detectors
A-A.5 Sweep Mode
The Sweep mode is used to operate the PMM 9010 as a powerful scanning
EMI receiver. To enter in this mode it’s enough to depress the Sweep soft key
on the main screen, and immediately the scan setup window pops up and
allows the operator to set the parameters for the scan. All the automatic
settings (RBW, frequency step, etc.) refer to the CISPR standard.
In Sweep mode the Peak, QPeak, C-Rms, RMS, C-Avg, Avg detectors are
available.
A-A.5.1 Detector
selection
To select the desired detector, from the main Sweep menu, enter the
Measure setup, then press the soft-keys labeled Level, Detector and choose
the proper one.
Pressing the Rms/Avg key these four more detectors are available.