PMM 9010-RMA Rack Mount Adapter 12-5
12.10 Installation
guidelines
When installing the chassis, follow these guidelines:
- Plan your site configuration and prepare the site before installing the
chassis.
- Ensure that there is adequate space around the rack to allow for servicing
the chassis and for airflow.
- If the rack has wheels, ensure that the brakes are engaged or that the rack is
otherwise stabilized
- For a round hole (tapped) rack, use
clip nuts with M6 x 16 screw
(not provided).
- For a square hole (untapped) rack (shown below), use M6 x 16
screws, plastic
round washers head screws and M6 cage nut
(provided).
To Next Page
Loading...
Need help?
General
