NARDA PMM 9010 Series User Manual

14-4 Remote control
Setting COMMANDs
Syntax Function
ASBK
Aborts a sweep currently in progress
ASPA
Suspends a sweep currently in progress
ASRE
Resumes a sweep previously paused
S3PRC
Sets the PMM 9010/03P/30P/60P to conducted mode
S3PRR
Sets the PMM 9010/03P/30P/60P to radiated mode
SAAT a
Sets Attenuator for Analyzer Mode
SADT b
Sets the Detector for Analyzer Mode.
SAFF start,stop
Sets both Start and Stop frequency for Analyzer mode.
SAGO
Sets the 9010 in Analyzer mode
SAHT h
Sets Hold Time for Analyzer mode.
SAOP f
Sets the Stop frequency for Analyzer mode
SAPA a Switches Preamplifier, for Analyzer Mode, On or OFF
SAPS a Switches Preselector, for Analyzer Mode, On or OFF
SART f
Sets the Start frequency for Analyzer mode
SCFA n
Activates the conversion factor stored in the 9010
SCFE n, name Saves the conversion factor (made by SCFW).
SCFW n, freq; lev
Creates a conversion factor frequency by frequency.
SDISDyn; RefLev;
Sets both Display Dynamic and Reference Level
SDMD a Switches the Demodulator On or OFF
SDMV v
Sets the volume of Demodulator
SLDW n, freq; levq, leva
Sets the custom double value limit frequency by frequency
SLIC n, name
Names the custom limit and stores it onto the SoftKey
SLIE name
Name the custom limit and making it active or deactivating it.
SLII n
Recalls and loads into PMM9010 the built-in limit
SLIM n
Sets the Margin to be used with Smart Detector function
SLIW n, freq; lev
Sets the custom limit frequency by frequency
SMAF f
Sets the tuning frequency for manual mode
SMAN
Sets the 9010 in manual mode
SMANP
Sets the 9010 in manual mode and sets the default value
SMAT a
Sets Attenuator for Manual Mode.
SMHC
Clears the content of the Analyzer Max-Hold array
SMHF a Enables the Analyzer Max-Hold function ON or OFF
SMHP a Enables/disables the Analyzer Max-Hold Pause ON or OFF
SMHT h
Sets Hold Time for manual mode
SMPA a Switches Preamplifier, for Manual Mode,
On or OFF
SMPS a Switches Preselector, for Manual Mode, On or OFF
SSDO
Triggers a sweep based on set parameters
SSDT b
Sets the Detector for Sweep Mode
SSFD
Sets parameters and triggers a sweep
SSFW n, freq
Creates a Frequency-Scan-Tab frequency by frequency
SSHT h
Sets hold time for Sweep mode.
SSOP f
Sets the Stop frequency for Sweep mode
SSPA a Switches Preamplifier, for Sweep Mode, On or OFF.
SSPS a Switches Preselector, for Sweep Mode, On or OFF
SPLM a Switches the Pulse Limiter; On or OFF
SRBW b
Sets RBW
SSRT f
Sets the Start frequency for Sweep mode
SSTP
Stops abruptly a running sweep in Analyzer mode
STAT b
Sets MinAtt
STGF f
Sets the tuning frequency for 9010 Built-In Generator
STGL l
Sets the output level of 9010 Built-In Generator
STGS a Switches the 9010 Built-In Generator On or OFF (a)
STGT a Changes 9010 Built-In Generator tracking mode On or OFF
SUPP n
Outputs on the User Port bit by bit the argument n

NARDA PMM 9010 Series Specifications

General

Brand	NARDA
Model	PMM 9010 Series
Category	Receiver
Language	English